Here I am

Engine dies...

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
H

Gear indicator issues

  • Herman8r
  • Replies: 59
A

Intermittent low power and engine clatter

  • ARigutto
  • Replies: 13
sag2 said:
Pull the ECM off and stick it in the oven at 175°. Plug it back in and fire it up without wasting any time. Leave it off the block so it does not transfer any heat out of the ECM. Long shot but free.
Click to expand...
Curious what this is proving. I know we use to place hard drives in a freezer before boot up on voicemail systems as a last ditch effort to get a system up. Freezing would allow the platter to spin up and load. Ecm is solid state so just curious.
 
You must log in or register to reply here.
Issue 128 – Digital Version
Digital Magazines
FREE!
TDR Test Drive - Digital Edition
Renew
Subscribe
Gift Subscriptions
Back Issues
Subscription Status
Address Change Form
Buyer's Guides
Ram Diagnostic Trouble Codes
The Perfect Collection
The Perfect Collection Vol. II
TSB Updates
Dodge/Cummins Historical Overview
Cameron Collection
What Makes Us Tick?
Product Showcase
Advertising



Turbo Diesel Register
Issue 128 – Digital Version
Digital Magazines
FREE!
TDR Test Drive - Digital Edition
Renew
Subscribe
Gift Subscriptions
Back Issues
Subscription Status
Address Change Form
Buyer's Guides
Ram Diagnostic Trouble Codes
The Perfect Collection
The Perfect Collection Vol. II
TSB Updates
Dodge/Cummins Historical Overview
Cameron Collection
What Makes Us Tick?
Product Showcase
Advertising



Back
Top