Gauge mounting plate

[vortex]

Looking to install Egt gauge and boost gauge. I think the small cubby hole under the radio is a perfct place. I have seen gauges installed there in a three gauge cluster. I have the electronic 4x4 swith there making it big enough for only 2 gauges, has anyone seen a 2 gauge mount to fit in this spot? Any thoughts of the best gauges to match factoy ones? Thanks Dave

 

[Mark Craig]

vortex,



There is a three gauge mount that goes in the cubby box area that is built by Gauge Works, it is a perfect match for the spot your considering, we sell a lot of them as they keep the gauges out of the way and don't block any vision like the A pillar mounts that mount on top of the factory A pillar. Speaking of that we now have the A pillar mounts that are made from the same material from the same supplier that DC uses that allow you to remove the factory A Pillar and use the supplied screw to mount the 2 or 3 gauge mount A pillar. You don't have to cut up the factory handle, just save it on a shelf for any future use you might have. The Gauge Works pillar has the same grain and color as the stock one so no paint is required etc and the gauges are set back into the pillar much deeper becuase the factory pillar isn't behind the new one so the gauges could be set in deeper to not block your vision !



Mark @ DPPI