Here I am

Engine/Transmission (1994 - 1998) Head Gasket

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1998.5 - 2002) Ever Break a Flexplate?

Engine/Transmission (1994 - 1998) Pre-emptive strike on kdp...

Status
Not open for further replies.
Trying to find the most boost ran on a stock head gasket I am currently running 46 psi . Please post your psi Thanks
 
Drag diesel is that a autometer gauge you are using? I am fabing up a hx55 right now and some custom injectors I am using a autometer 60 psi gauge and plan to put a inline blow off valve, was going to be at 55psi maybe at 60 psi now thanks for the info
 
It should hold 60 psi from time to time. But I would NOT count on that being a permant fix. Infact I wouldn't run it up their too often at all. Plan on doing something to take care of your head fairly soon before something BAD happens and it's more expensive than it could have been.



JMHO



Russell
 
Buddy of mine in Indiana hits 75 psi with his stock head gasket. Ht3b and 35 w/40 housing. Says it gonna go one of these days, but until then he ain't touchn' a thang, and i don't blame him. I think alot of it is checking your head bolts from time to time, and making sure the engine is warm enough to run hard.
 
this is kind of a related question, not trying to steal attention, but how much can the stock turbo/injectors make? i just have an air filter and a tst plate, with the adjustable elbow... . can i turn it up much? will it affect preformance much?
 
Datablitz

You can run it full tilt but you have to watch you egt's. i have installed a #6 in dads truck and run it about 3/4 way ahead. point being it doesnt matter where it is it will still make power,BUT you have to watch your egt's. just watchout cuz your auto will crapout on you.



go balls to the walls or get out of the drivers seat.

Andy
 
Status
Not open for further replies.
Back
Top