Archived Help,,,,,Injectors in now a dead miss

[SHobbs]

Whats the possibilities of a new set of injectors not working properly? Dropped a set of 275's in yesterday and now I have a dead miss when the truck is running, dang thing barely idles forget any acceleration. It cranks just fine starts right up just with a noticeable miss and alot of shaking and stumbling. My oil level has not risen so I don't think any fuel is going into the crank. There are no leaks and everything is buttoned up as it should be. Anyone experience this before? My only other option right now is to put the originals back in and get the 275's tested or whatever to see if they are working or not.

 

[DCreed]

If you havent already ,go back over your install sequence and be sure all is aligned and seated correctly as it is easy to cause a leak at the connector tube to injector seating.

 

[Jason Griebel]

How long did you run it sometimes after you bleed out the injectors and fire it up it will start and run on but take alittle bit to get them all firing right usually clears up in a minute or so.

 

[SHobbs]

Well turns out that one of the injectors is not firing. I pulled every one out and the one in the number 2 hole was clean as a whistle. Dropped the originals back in and it fired right up now at least I can get to work. Have to settle this minor problem tomorrow. Thanks guys for the suggestions and help.