Engine/Transmission (1998.5 - 2002) Injector install (again)

[TSRAM]

Have a used set of injectors on the way 'yall. For those of you that have done this numerous times, what do you recommend having on hand before beginning? I have the instructions that were floating around here some time ago along with some other sets. I'm wondering about re-using o-rings or copper washers...

I'm assuming the inj. won't come with anything extra being used once already.

 

[MKresch]

DO NOT REUSE THE O-RINGS! any time you change injectors you need to use new o-rings. if not it may develop a leak. i would also put in new washers for insurance. before you install the injectors put a little oil on the o-ring to help it slide in otherwise you may tear the o-ring installing it.

 

[SEmerson]

Being cheap I reused every thing. And have had no problems.

 

[TSRAM]

From what I've been reading both here and older posts, I take it that you can re-use but most don't. OK, so tell me if the following part numbers are correct (no I don't have the serv. manual yet)

intake gasket--3913352

o-ring seals (6)--3910824

dont have #on copper washers.

Found these two on the Cummins site, but there is no breakdown or view to follow.