Engine/Transmission (1998.5 - 2002) Injector install question

[Joe Mc]

I have these instructions. http://www.lib.uaa.alaska.edu/~tibor/DD-Injector-Install-Instructions.pdf

Should I need anything else? I can only find 6" bent tip needle nose, should they be OK? or, do I need bigger? Just want to be sure before I get started tomorrow as wife's car will not be there for a backup.

 

[RonA]

I use a pocket knife to pop the cross over tubes out. I also like to keep a few extra o-rings handy in case the ones on the tubes look bad. Don't over tighten the lines.

 

[lmills]

the worst part is injector number 6 on the 24 valve. Have a crows foot for your ratchet, or take an old wrench and bend it for access and the rest is a breeze.

 

[kelly4463]

JoeMc -if you can wait until sunday iam off of work we can do it at my house i have all the tools Oo. Oo.

 

[Mike760]

I just started replacing mine today. It's a little more work than I expected. Everything is going well so far. Injectors are in. We plan on replacing the valve cover and fuel lines in the morning. Hopefully we will road test by noon!! +++++HP!