Attention: TDR Forum Junkies Can anyone tell me the procedures for testing 275 hp injectors? I have a set I recently purchased and had them tested. I watched the guy do it but I didn't see any procedures. He just hooked them up & did it. They atomizied well, and are in the 278-290 bar range. but dribble at low pressure. Can the tester person make them dribble? Is there a time limit they should hold pressure? (He never did a hold test) I'm not sure just yet if I want to install them. The guy I bought them from says they have 33k mi. on them and never had any problems. Any references to info would be highly appreciated. Comments are appreciated too.
Thanks
Thanks
