Archived Installing HTT manifold

[GCurrie]

Hi All,

Installing a HTT manifold this weekend. (I posted this on the 2nd Gen Engine as well. )



I use the auto hobby shop on Camp Pendleton to do the work. They have a parts counter, but unfortunately they were out of Loctite and Anti-Seize, and I was too far along to go get some from in town. Are these necessary?



I am using all new hardware that I went and purchased from the local dodge dealer, and the manual does not mention using either.



I am at a point where I can pull the turbo back out pretty easily and use either or both, tomorrow.



Any advice would be appreciated.



Thanks

Gary

 

[Bob4x4]

Hi All,

Installing a HTT manifold this weekend. (I posted this on the 2nd Gen Engine as well. )



I use the auto hobby shop on Camp Pendleton to do the work. They have a parts counter, but unfortunately they were out of Loctite and Anti-Seize, and I was too far along to go get some from in town. Are these necessary?



I am using all new hardware that I went and purchased from the local dodge dealer, and the manual does not mention using either.



I am at a point where I can pull the turbo back out pretty easily and use either or both, tomorrow.



Any advice would be appreciated.



Thanks

Gary

Using anti seize would be nice but not required. Button it up and call it good.



Bob

 

[mberry]

Bob is correct. I didn't use any if that matters to you. Semper Fi.

 

[Smokin_Monster]

None of that here either. Just fine.