Here I am

Is this a TDR member?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

New Cicada thread + AHB in Louisiana

Ford with a V 6 Cummins engine?

I know that truck! However I sure as hecl would not be standing behind a set of 38 inch swampers on a full dyno pull!!! God my BFG's were huckin' pieces I can only imagine those @ 50 -> 100 mph dyno pull :eek:
 
I was getting ready to say RO'neal... but he dont have the chrome around the lower body panels and I don't think he has Super Swampers. At least he didn't when I was watching him install a SB Clutch at his dads transmission shop. Speaking of... I havent seen him in a while. He was back in town here after being in South Carolina (Marines) for a many years. He was working at his dads transmission shop... but I haven't seen the big dodge around town. I see his brothers 1st gen once in a while. I'll have to flag him down and see where he's been.



As far as the smoke, stacks and lift goes... it sure does look like his.
 
Here are Ryans photos. His truck has gone through alot of transformation and is very, very nice. He works it hard as seen in the mudding photos. But it cleans up like new again and looks great. It appears he may have installed SSR tires.



They are some really great photos of action in the mud.



RO'neal's truck



Others



Even More
 
Last edited:
the stacks on the truck on the dyno are straight up wiyh out a turn at the end. The ones in the other pistures have a bend. I think this is another truck. Unless of course he has made some more changes.



Chris
 
RO'neal sold his truck back in January. He was, (is) a moderator at Pavement Sucks. Goes by "Motorhead" there. Here's a link about it.

That sure is a sweet truck on the dyno.



Brad
 
Back
Top