Attention: TDR Forum Junkies I have the 5500 series Isspro tach (4k) and the pickup kit (magnets + pickup).
Tach works fine at idle... and to about 1800 rpm. BUT when slowly going over 1800... the tach needle goes up to 3200 to 3500 rpm.
I "believe"{ that my gap is set correctly (1/8 to 1/4").
I swear that I found a thread one time where a person had the same trouble. (can't find it here... I have searched)
Figured I would ask the TDR what they thought before I called Isspro in the am.
Thanks
Jim
Tach works fine at idle... and to about 1800 rpm. BUT when slowly going over 1800... the tach needle goes up to 3200 to 3500 rpm.
I "believe"{ that my gap is set correctly (1/8 to 1/4").
I swear that I found a thread one time where a person had the same trouble. (can't find it here... I have searched)
Figured I would ask the TDR what they thought before I called Isspro in the am.
Thanks
Jim
