Engine/Transmission (1998.5 - 2002) Isspro EVM Fuel Pressure Guage

[DLBurns]

Waiting patiently for Isspro to come out with the Enhanced Visibility Marine - Fuel pressure guage

My pressure are OK for now, but I do want to add a FP guage just to give me piece of mind. All of my other guages are the EV Marine, white face with blue back lighting. I would like to keep them all the same if possible.

Any ideas as to when we might see one?

Dave

 

[Piston Slapper]

Check out my readers rigs sections. I have the fuel pressure gauge. What do you mean you are waiting for it to come out? It has been out. I have had it for months, probably close to a year.



More picturs in my readers rigs section.

 

[DLBurns]

Over a year!!

Where the &*^% have I been??

Where'd you pick yours up at?

 

[Piston Slapper]

Good ol Rod @ Wildcat Diesel

http://www.wildcatdiesel.com/

 

[DLBurns]

Thanks!!

Thanks Slapper!

 

[Sixpack]

Piston Slapper, did you buy the kit with the stainless line and shut off valve?

 

[Piston Slapper]

No, I went the cheap route. I am on the "Stainless is overkill in some cases" bandwagon.



I used the same tubing and fitting that are supplied with a boost gauge or oil pressure gauge. If it'll hold 80 psi of hot oil it'll hold 15 lbs of cold diesel! I did put a shut off vavle on the filter housing as a quick shutoff if it does leak. Total cost $10.



Check this post or my Readers Rigs for a PIC.



https://www.turbodieselregister.com/forums/showthread.php?threadid=69938

 

[DLBurns]

Just ordered the gauge, isolator and steering wheel pod from Doug & Andy at Smokin Diesel... Blair's gonna do the install!

 

[ToolManTimTaylor]

Originally posted by Piston Slapper





I used the same tubing and fitting that are supplied with a boost gauge or oil pressure gauge.

BTW what the heck is that Dia tubing anyhow? 1/8?

 

[Piston Slapper]

Originally posted by ToolManTimTaylor

BTW what the heck is that Dia tubing anyhow? 1/8?

Dia? Diameter of the tubing? Yes, it's 1/8 inch... It works fine too.