Looking for sources on 1st Gen trucks.... (to purchase)

[Archive]

<font color=blue>Was wondering if anyone knew of a good place to look for some good condition 1st Gen trucks.

Looking for 3/4 ton, Reg cab, 4x4 Cummins of course..... to use for snowplowing on the side. Preferably under $6500.

Any information or websites or tip swill be apprciated.

Thanks<font size=-2>

[This message has been edited by KatDiesel (edited 01-31-2001). ]

 

[Archive]

It is kind of a local thing I would say. No one real big source. You could keep your eye out on ebay.

------------------
90 W250, 5-speed, isspro gauges, 16 cm2, K&N, Borgeson shaft, JRE 3" exhaust, Banks Intercooler

 

[Archive]

Good Luck, I've been looking for about 6 months now for 92 or 93 W250 club cab, have found a few out west, which might not be bad for you, but can't find any on the east coast.

Check out the following sites, I always find some on them http://www.trucktraderonline.com/adsearch.html
Also check out Trucktraders big truck site, when your on the trader page above, listed below is another site I've found:
http://www.awtrucks.com/inventory/inventory.htm#DODGE

Good Luck - If you find one or if anyone else reads this, I'm still looking.

Wanted - 92/93 W250 Club cab, long bed, trailer package (5th or goose) Captains chairs, loaded, prefer white or two tone!
Thanks - Nollie
North Carolina


[This message has been edited by Nollie Neill Jr (edited 01-31-2001). ]

 

[Archive]

Might also try autotrader.com. They have a lot of trucks across the country. I am looking to sell mine, then get a SRW 4x4 after I get back from horseshoeing school and make a little money.

Daniel Puckett

------------------
Daniel's current truck: 1993 W350 club cab, 5 speed, treadplate aluminum flatbed, 4. 10 rear end, straight pipes, K&N, "slightly" tweaked pump. ISSPRO color coded pyrometer and 50psi boost guage. NRA Life Member (since age 12) and d@mned proud of it. IRBCTS.