Measurements of PDR intercooler

[bgilbert]

I'd like to know the measurements of the intercooler PDR sells, Pete. Actually just the thickness of it. Whether or not it's thicker than the stock 91. 5-93 IC. How much thicker if so?



This would be for my 89, I don't have much if any extra room over the stock 1st gen IC in the thickness, I think it's 1. 5". No room for a Ford IC.

 

[PToombs]

I think it's stock thickness Bill. I know the cross tubes are huge! I'll measure it for sure when I go out in a little while.

 

[PToombs]

Bill, sorry forgot to measure it , then forgot to post!



1. 5 thick, stock ends, stock height. Tubes are 3/8, stock was 1/8 thick.



Sencha a PM!

 

[Don Tanklage]

pete, what size is a hht stg IV trubo and where did you dyno your truck?



thanks, don

 

[PToombs]

Don, the Stage IV is just the compressor half. 60mm wheel and a machined housing. Dyno was local here outside of Syracuse.

Load type. (I bet you were gonna ask that, huh?) :-laf

 

[bgilbert]

Thanks Pete. I forgot I can inspect it real good here in a couple weeks. I think we'll all have some good conversation material around the camp fire this year about intercooler and aftercooler efficiency. I'll probly stick with the water cooler, just try a bigger water pump.

 

[PToombs]

Bigggeeeerrrr puuummmmmp. Bigggeeerrrr puuummmmp. :-laf :-laf

 

[dpuckett]

Keep the beer guzzling to a minimum, guys. Now, it's a big pump. What's it gonna be next year?



I still think you need to go back to non-wastegated air to air.



DP

 

[PToombs]

Philip and I were discussing this and agreed that an I/C isn't going to help him any on the dyno. Kids! They never listen!





Think he'll listen next year when I'm up to where he is on hp? :-laf