Hey NE Guys,
I know I've been a bit of a no show lately as I've been SWAMPED at work, but i finally had a chance to dyno my truck Sun at UnLimited Motorsports in S. Windsor, CT w/the mods shown below. My best pull was on 5x5 and I made:
400 RWHP at 2700 rpm
800. 8 RWTQ at 2500 rpm
The trans was slippin pretty bad too on 5x5. I dyno'd in 3rd too. Is that right? I tried 4th once, but it just pushed through the converter. My trans is stock too (but not for long)
So, how'd I do?
I need to do my fuel system next, then TC, then turbo/dp/exh and I'm done
I hope I did you guys proud!!! There were two Duramax's there. One of which had a VA and was Jannetty sponsored (or so he said), and I out dyno'd both'em at 350 & 376 RWHP respectively. They made only 640 RWTQ too. The Jannetty truck was talkin so much garbage til I dyno'd and then , he just shut up.
These were my 1st dyno runs too.
My goal is 1000 RWTQ and 500 RWHP if that possible.
I'm gonna try and make it to the next NE event too. Take care guys.
I'm open to input, ideas, criticism.
Oo.
I know I've been a bit of a no show lately as I've been SWAMPED at work, but i finally had a chance to dyno my truck Sun at UnLimited Motorsports in S. Windsor, CT w/the mods shown below. My best pull was on 5x5 and I made:
400 RWHP at 2700 rpm
800. 8 RWTQ at 2500 rpm
The trans was slippin pretty bad too on 5x5. I dyno'd in 3rd too. Is that right? I tried 4th once, but it just pushed through the converter. My trans is stock too (but not for long)
So, how'd I do?
I need to do my fuel system next, then TC, then turbo/dp/exh and I'm done

I hope I did you guys proud!!! There were two Duramax's there. One of which had a VA and was Jannetty sponsored (or so he said), and I out dyno'd both'em at 350 & 376 RWHP respectively. They made only 640 RWTQ too. The Jannetty truck was talkin so much garbage til I dyno'd and then , he just shut up.
These were my 1st dyno runs too.
My goal is 1000 RWTQ and 500 RWHP if that possible.
I'm gonna try and make it to the next NE event too. Take care guys.
I'm open to input, ideas, criticism.



