Attention: TDR Forum Junkies 
I need some help guys. I installed a VP44 today and while I was removing the rear most clamp down bracket for the High Pressure lines for cylinder 5 and 6 I dropped the clamp pieces. Now I'm not sure if I have all the parts.
This is the rear most clamp that attaches to a bracket for lines five and six. I have the two blue plastic pieces that go under/over the lines and I have the metal clip that goes on top of the upper blue plastic piece. What I'm not sure of is if there is a metal clip that goes under the lower blue plastic piece, or does the blue plastic piece just sit against the bracket.
If someone could take a look at their engine, or even take a picture and post it, I would greatly appreciate it.
Thanks
This is the rear most clamp that attaches to a bracket for lines five and six. I have the two blue plastic pieces that go under/over the lines and I have the metal clip that goes on top of the upper blue plastic piece. What I'm not sure of is if there is a metal clip that goes under the lower blue plastic piece, or does the blue plastic piece just sit against the bracket.
If someone could take a look at their engine, or even take a picture and post it, I would greatly appreciate it.
Thanks
