Here I am

New Projector headlights

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Steel hoods or fiberglass?

On Board Air Compressor.....

Status
Not open for further replies.
Just got these lights installed and adjusted. . Don't have a pic of the truck yet but here is the pic of the lights.

Got what you see here for $158 + Shipping. . A real bargain.

My truck is a 2 headlight system so naturally I have a problem with the high beam. What I did is, ... wire it like a fog light. (the high beam side that is) Separate switch and power to a relay and ... presto!! ... high and low beam on at the same time!!

Don't have the new fog lights in yet as I am dodging snow showers on my weekends. . . The projector beam is so much different from a normal headlight, it gives it a flat, wide light that is put where you want it... and the high beam shines 5 blocks away!!

Anyway, can't wait to show them off at May Madness this year!
 
Bi-Xenon headlights are better. I have them on my Truck. I also have HID projector yellow foglights running as daytime running lights installed in stock foglight location. ;)
 
Last edited:
Any kind of lights would be better than my lights. They have turned yellow from age. Very interested how these new lights work, including the wiring diagrams. MOE
 
Light for the low beam are plug and play. .

I plan on getting better lights for the low beam as they are better than stock but not as bright as a cadillac Escalade. Just need to get better inserts

For the high beam... . you need to cut the wires for the high beam both black and red. . and wire up like a fog light on a separate switch. . Run power to a switch mounted by the turn signal stock... from the switch, run wire to a relay. hook to #86 terminal and opposite terminal #85 to ground... . the #30 terminal and the #87 terminal are the battery side and wire to "+" side of lights respectively . . black wire from lights to ground then... . Flip switch and high beam is on... if lows are on, highs are on at the same time low beam is.
 
I have been running pure HID for three years now. They are great on dark roads. I plan to upgrade the brights to HID because the low beams are brighter!
Rick
 
Status
Not open for further replies.
Back
Top