Here I am

News on 3 guage pillar mount ?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Hobbs vs. Miles

Cowl hood seal

Status
Not open for further replies.
Any news on the whereabouts of a 3 guage A-pillar mount pod?

------------------
'01 2500 SLT+, QC, LWB, 4X4, 3. 54s, AT, every option but running lights! To come: 19. 5"s (?), lift, Line-X, Exhaust brake, 4" turbo to tail, etc...

'98 DUCATI ST2 "Bombed" 944CC with Ducati Performance Carbon Fiber Exhaust, F. I. M. Chip, K&N and "modified" air box.
 
Nuthing new on my end, just sent another email to Lo-Tek Engineering to see if they have anything to say.

Also you should state whether or not you have the tweeter, I have see 3 gauge non tweeter pillars.
 
What's Lo-Tek's email address again? I'm looking for a 3 guage mount w/ tweeter.


------------------
Randy Jones, San Antonio, TX, 98 1/2 QC, 4X4, American Racing BAJA's, 285/75/16, Amsoil throughout
 
Oops... . I should have specified the tweeter option as well... . I guess it was assumed with my model year! (What?... . you guys can't read my mind?)

[This message has been edited by Scooby (edited 06-13-2000). ]
 
Scooby -

I figured you had the tweeter, but just wanted to clarify for everyone else.

Lo-Tek's Email : -- email address removed --

Lets FLOOD their emailbox so that they HAVE to listen to us.

I went with a triple gauge dash pod but the one Summit sent me is defective!!! So still no gauges for me #ad


#ad


The PowerEdge won't go in until I can get my gauges in!! (Ecspecially the transmission temp)

[This message has been edited by KatDiesel (edited 06-13-2000). ]
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top