Here I am

No OD, wait to start + water in fuel lights on/flashing

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Just a note of thanks

Which Fuel Pin for Gen 1 ?

Status
Not open for further replies.
Hi,

Does this randomly. Grid heaters work as does the WIF sensor.

Overdrive off switch clicks & lights as usual, but no OD sometimes.

When this happens, the water in fuel & wait to start lamps light steadily & sometimes flash.

Its a 91.5 with no crank sensor or tach plug, and an ECM with an external regulator.

Truck doesn't have AC or cruise.

Thx!
 
Bad ground or bad SBEC module, could be either one. Start by scraping and tighten all the gorund points under the hood and the dash.
 
I did the OD module tests -

If fuse is good probe BLUE/WHITE with grounded test lamp. If it lights this way, you have a bad ground

This is what I got - I show full voltage testing the engine, firewall and dash grounds.

Any thing I'm missing ?
 
Status
Not open for further replies.
Back
Top