Attention: TDR Forum Junkies 
PPI A600 & TRI-WAY ? Good or Bad application
--------------------------------------------------------------------------------
Hey guys, Been working on my 01' Dodge Ram extra cab. It all started w/getting an ipod for x-mas that wouldnt connect to my factoury headunit. So I did the JVC HD deck & ipod adaptor . Did some 6 1/2 2 way Eclipse point source (sp8962) in the front doors powered by factory infinity system. Ive been messing around with the rear speakers . Currently have a 2-channel PPI A 600 amp, Orion xtr mid bass 6 1/2 400w rms @ 4ohm in the rear doors. These are ran off the deck rear rca's. Ive run these bridged (parallel). Didnt see much diff. Might have done wrong by not connecting the open speaker connections on the amp ? Just did 2pos & 2neg together, left then right side, leaving the other two speaker connections alone. I wish I could find a manual for this amp. Curently just hooked up reg. I was wondering about bridging & doing the try-y thing to a 10" JL DVC sub I have. (sub is 10w3-d4 dvc w3) Behind center console is the perfect place for it. Think this is enough amp? I also have a punch 160 4 channel thats bridgable that could drive that sub too, but dont wanna lose any more underseat space. I dunno, any thoughts ? Thanks in advance--ProflowPPI
--------------------------------------------------------------------------------
Hey guys, Been working on my 01' Dodge Ram extra cab. It all started w/getting an ipod for x-mas that wouldnt connect to my factoury headunit. So I did the JVC HD deck & ipod adaptor . Did some 6 1/2 2 way Eclipse point source (sp8962) in the front doors powered by factory infinity system. Ive been messing around with the rear speakers . Currently have a 2-channel PPI A 600 amp, Orion xtr mid bass 6 1/2 400w rms @ 4ohm in the rear doors. These are ran off the deck rear rca's. Ive run these bridged (parallel). Didnt see much diff. Might have done wrong by not connecting the open speaker connections on the amp ? Just did 2pos & 2neg together, left then right side, leaving the other two speaker connections alone. I wish I could find a manual for this amp. Curently just hooked up reg. I was wondering about bridging & doing the try-y thing to a 10" JL DVC sub I have. (sub is 10w3-d4 dvc w3) Behind center console is the perfect place for it. Think this is enough amp? I also have a punch 160 4 channel thats bridgable that could drive that sub too, but dont wanna lose any more underseat space. I dunno, any thoughts ? Thanks in advance--ProflowPPI
