Archived Reinstalling motor in '03, getting about 17 codes on dash..

[Pirate4x4]

Truck has absolutely NO power, and runs very rough. Sets about 17 codes on the dash, from "too high of fuel rail pressure" to "Injection pump fuel valve feedback" to "ECM/PCM Power input signal intermittent".



What would cause this? There are no boxes on the truck right now, just trying to get it to run!



Double checked all ground wires, etc. Gauge shows proper oil pressure, temperature, and charging voltage.

 

[rashwor]

I assume the motor you are installing is the one that came out of the truck (the ECM matches all the other on board computers)? Why was the engine removed?

 

[lmills]

if I remember right, I think he might have ingested some turbo debris

 

[bulabula]

I'd triple check all electrical/sensor connections for accuracy and cleanliness.