Here I am

Reloading Costs

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Sears dome tents

What do you'll think?

I know all about the advantages about reloading, but haven't done it in many years. What's happening with costs for rifles these days. I know it depends a lot on component costs - but say you're using good bullets, not cast ones, what does it cost per round..... As an example this past summer I picked up a 45-70 Marlin guidegun. I want to load some stout loads.....
 
I got 100 rounds of brandy new Winchester brass for mine for $30. 00.

1000 of the bulk Remington 350's or 405's costs about $130. 00- $140. 00 + shipping. (Why buy less? :D ) Hard cast lead is about the same, might as well run jacketed... ... ... especially if you want to run the bullet at a velocity where this rifle will let you load it to.

You must have a good idea on powder and primers. Need dies?

I figure you can do it for about . 50 a round, and 45-70 brass should load a good long time, so the cost will drop at each reload. :D

This is about 1/2 of what the factory loaded round costs.

Eric



BTW, I recently got a Guide gun!!!:p Oo. Oo.
 
In my experience, anyone who reloads ammunition to save money is not facing reality. What it will do for you is allow you to feel good about shooting more, which is always a good thing. :D
 
I agree with riflesmith. When I first got into reloading I "thought" I was doing it to save money. In the end I've spent more than I would have otherwise. I do shoot more than I did not reloading though. The biggest thing I get out of reloading is more accurate loads for my guns (that takes time in developing the right loads), a wider selection of loads than I would using factory ammo, and I get to shoot wildcat rounds that I simply couldn't do since you can't buy off the shelf ammo for them. JMHO



-Steve
 
Back
Top