Rod Ends/Heim Joints

[CUMAPART]

Anyone else out there using these. I'm looking at 5/8 hole and 5/8 thread (LH). Making up tie rod and drag link. Checked in Summit and Jegs they have them but pretty pricey. Just wondering if anyone has a good spot to shop at?

 

[Hammer]

Ah Yes Moscow, PA my old stompin grounds,,Former home of Ghost Town at the Glen(long gone) and Preffered Meals,Defazio Express(dissappeared) and not too far away from the whole friggin culdesac that Joe Amato bought for his mansion and you,,The easiest place for you to get the parts you want is at S&W Race Cars in Spring City,PA(bout a hour drive south of you down the tpke),,Their number is on the web here. . www.swracecars.com . . ,,You could also call Ed Quay Race Cars in Pottstown,PA,,His website is www.edquay.com ,,Make sure if you do it you run a hardened washer under the heim joint in case it would fail so it will not drop allow the suspension part to drop to the ground,,Just a couple for you to look at locally,,Hope this helps..... Andy

 

[CUMAPART]

THANK YOU Andy. Ah yes Rocky Glen and just a little house that Amato built. Your forgetting the once was Nay Aug Zoo. Thanks for the links I'll check htem out.