Sagging front end

[Slow Six]

The front end on my 03 3500 4X4 is getting settled out. I would like some ideas to raise it back to new height. Does any one make spacers for this or should I be looking for an after market spring. I do not want an off road set up as most of my use is towing, a lot of it with our 5th wheel so I want to maintain ride quality.

 

[CPG]

This is not a uncommon thing with our trucks. Mine is a 04. 5 CTD HD & even when new, the front end sagged too much. This week I went to a front end shop to have this subject answered. My reply was to have spacers installed as most springs go through a break-in period in a few years and seldom progress beyond this. The metal is not the same as former years. I will have the spacers installed instead of newer heavier springs.

 

[Slow Six]

Who supplies the spacers?

 

[CPG]

Most 4WD shops or spring shops.

 

[DocDetonancour]

i have revtek and am satisfied. truck is level for less than 300 bucks



[/I]

 

[Slow Six]

I had a few minutes and did some looking around on the net. I am wondering if any one has used the Kore HD levelling kit and what do you think about it? I want to do the job right and if ride quality improves that is a bonus. Doc, what is revtek? Thanks for replies so far.

 

[Desert Proven]

The KORE springs are top notch. Give a call to High Rollerz, they are the KORE distributor up in Canada.



High Rollerz Trux - High-End Suspension Systems - Truck Customization - Off-Road Accessories