Here I am

Salt Lake City Get Together

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Anyone passing through MO on their way to May Madness?

April 12th Dyno Day In Meridian Idaho

There will be an informal get together in Salt Lake City this Saturday, September 28th from 12:30pm until ????. You do not have to be a member of the Turbo Diesel Register to participate. This will be a VERY informal get togther where those interested in Dodge Cummins diesels can get together and talk about their beloved trucks. The get together will be at Dee's Family Restaurant located at 7203 South State Street in Midvale. (See end of this message for driving directions. ) If possible, we will all try to park on the east side of Dee's parking lot at 12:30pm. There is a 20% chance of rain on that day. If it is raining at 12:30pm, we will all meet inside.



Again, this is a very informal get together just for fun. This is the first get together here like this that I'm aware of. If all goes well, we may do this again. If you have any questions or ideas, please feel free to call me.



Bucky :)

(801) 563-7179



Driving Directions:



Exit 7200 South from I-15 and head approximately one mile east. Dee's restuarant is located at the intersection of 7200 South and State Street on the southeast corner. If you are headed east on 7200 South, stay in the right lane, go through the intersection of 7200 South and State Street and turn into the entrance on the north side of the restuarant.
 
I'm really going to try and get there. I've got a couple of projects going this weekend and will make my determination closer to 10:30a on Saturday. (Shed & Exhaust Brake)



Thanks,



Corey

801-593-9705

801-540-9557
 
I would luv to meet you all but I'll be in Logan at a match with my daughter all day this saturday, maybe another day in the future we could meet down at Phantom racing and dyno on there Dynojet...
 
drawson



Some of the guys, including myself, that are meeting this Saturday are listed in in the Travel Companion so stay in touch for future happenings. Give me a call anytime you're in the area and I'll meet you for coffee or a bite to eat. Good luck to your daughter on Saturday.



Bucky :)
 
Its looking good for me. I've planned to leave here about 10ish am and swing by menlove for the 1st oilchange. She's got just over 1300 miles on her.



After that, I'll be on my way. Should give me about 45 min to find you guys (GPS Assisted).



I got more of the shed done than I had anticipated. Power ran, compressed air line ran, floor, walls, roof & shingles all done. The wife is going to paint it tomorrow while i'm gone, and I'll finish up the rest when I get back. I haven't heard yet about my exhaust brake, so I doubt thats in.



So, looks like noon 30ish, be on the look out for a Blue, non-plated xtd cab long bed 6sp to be rolling in ;)



Later,



Corey

801-540-9557 cell'r phone
 
Boy! this is what I was tryin to do for the last 2 yrs. just to get together here in Utah will be great. !



Corey, good to have a place to drive it and show it off, huh? I know,, Well getin late, gonna detail my baby tomorrow so i will show up with an appetite!



Eric
 
Corey...



Punch this in to your GPS:



N40 37. 215

W111 53. 431



Look



This should put you within a few feet of the location. If you start to see signs that say "Welcome to Idaho", one of us has the wrong coordinates.



Your truck has even less miles on it than mine. I'm at about 2100 miles on mine but most of these miles are because I picked the truck up in Tulsa. Just got my strap wrench and half inch drive extension today. Sunday will probably be the day I do my first oil change.



Leaving your wife at home to paint the shed? She sounds like a good one. ;)



See ya Saturday...



Bucky :)
 
It was great gettig up with you guys on Saturday. We sure will have to do this again sometime!



My number is below if you want it!



Corey
 
I was just thinking the same thing the other day. I have weekends off still.

I haven't been able to contact Dave (big Dawg) lately, anybody know where he is?



Where would we want to meet this time?
 
Sorry guys, I dropped the ball, I was in the middle of working on some school projects, work and building a roll cage for a guy and forgot all about this. Somebody has posted a question if anybody wants to do this again, I found the link by accident, and don't remember where I found it, but they are planning about mid-month of April. I've got an Exercise that week/weekend and doubt I'll be able to make it. I thik it was the 19th??



Corey
 
Back
Top