Hiya folks,
This filter was recommended to me when I expressed an interest in putting on a FASS. I found one for a mere $69 and now have it. So... does anyone have experience installing this and have pointers or recommendations to pass on? I've searched the forum and found a few threads discussing the filters but nothing on the actual installation of it. If I interpret the wiring correctly the WIF moves to the new "pre-filter" and the old sensor plug gets filled with dielectric, the heater pigtails off the existing 14ga red wire, and the power wires go directly to the battery posts.
Is there anything I should watch out for?
Is there an alternative filter? I've seen that there may be a Mann filter which can be used but I haven't found a part number for it. Oh, I also have the 57 gallon Titan Fuel Tank but haven't yet slid under the truck to see if the recommended mounting location is accessible or not. If not, has anyone mounted it somewhere else?
Any constructive comments are greatly appreciated!
Thanks
This filter was recommended to me when I expressed an interest in putting on a FASS. I found one for a mere $69 and now have it. So... does anyone have experience installing this and have pointers or recommendations to pass on? I've searched the forum and found a few threads discussing the filters but nothing on the actual installation of it. If I interpret the wiring correctly the WIF moves to the new "pre-filter" and the old sensor plug gets filled with dielectric, the heater pigtails off the existing 14ga red wire, and the power wires go directly to the battery posts.
Is there anything I should watch out for?
Is there an alternative filter? I've seen that there may be a Mann filter which can be used but I haven't found a part number for it. Oh, I also have the 57 gallon Titan Fuel Tank but haven't yet slid under the truck to see if the recommended mounting location is accessible or not. If not, has anyone mounted it somewhere else?
Any constructive comments are greatly appreciated!
Thanks
Last edited: