Here I am

Smarty at the track on an otherwise bone stock 04

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Is my Lift Pump dead??

Hard starting Fuel heat sensor or element problem I think

Status
Not open for further replies.
Had a chance to hit the 1/4 mile tonight.



This is on my 04 305/555 with a stock 48RE auto transmission with 94K on it. Ambient temps were running about 85.



Stock:



1/8 mile 10. 445@66. 72

1/4 mile 16. 32@82. 81



Smarty Level 5

1/8 mile 9. 35@76

1/4 mile 14. 47@96



Smarty Level 7

1/8 mile 9. 26@77

1/4 mile 14. 33@97



Smarty Level 9

1/8 mile 9. 25@77

1/4 mile 14. 32@97



BTW, ran a scan tool on a couple of the #7 runs and the rail pressure never reached 24,000 psi. It also never dropped on the big end of the track.
 
Last edited:
I didn't have the scan tool hooked up when I ran it stock so I don't have the numbers for that run. My biggest concern was the max rail pressure.



As far as I'm concerned, it's a non-issue to me now.
 
Gauges are currently enroute via a TST PMCR. I'll make some more runs when I get them on.





JVolpe ran a few passes too. I know he ran 13. 08, but I forget what he had running on that pass. I konw he ran a 13. 1 with the Smarty and the Edge EZ on it's lowest setting. He's got a turbo and a built trans though.
 
Status
Not open for further replies.
Back
Top