2nd Gen Non-Engine/Transmission stack question

[mfunderburgh]

I'm getting ready to put a single 5 inch stack on my truck and am wanting to run the exhaust piping between the frame and bed and right up where the stack will be. My question is will I be able to do this with 5 inch elbows and pipe or am I going to have to settle with 4 inch until I get out of the bed. I can't come up in the middle of the bed either because that's where my auxillary fuel tank is going to sit some day. Thanks

Matt

 

[smittybuilt]

i wish i had a pic to show you but i believe you might be able to. i put a piece of 5" pipe on the end of the stack and then welded the end up and drilled a whole for drainage. then we went back and cut a whole in the side of the pipe and slid a 4" piece of pipe in the whole and welded around it and then elbowed everything over and down and tied right back into my existing 4" exhaust. good luck!Oo.

 

[midwestdually]

why only a single stack??

 

[mfunderburgh]

still need bed space

got to leave room for a auxillary fuel tank to the left to fuel up the equipment. I guess one stack is better than none?

 

[Got Smoke?]

Re: still need bed space

Originally posted by mfunderburgh

got to leave room for a auxillary fuel tank to the left to fuel up the equipment. I guess one stack is better than none?

I'll be getting 2 Saturday!Oo. Oo. Oo. Oo. Oo.