Here I am

Tach help

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Fuel Solenoid Question

Pump/injector assembly questions

Status
Not open for further replies.
Just put a 4500 in my Dads truck and now there is only one problem left to solve. He has the Issopro tack in it with the sensor on the balancer. His tach works every time at startup but after a few miles it quits.

I insalled it a few years ago and with all of the other gauge wires running between the brake and up to the A-pillar I hate to remove it all out just to check it out. The sensor clearance checks out when it is not running. Any ideas why it quits after running a while/warmup?
 
I would double check the gap to make sure it's correct... possible that thermal expansion is throwing it off because the gap is not perfect???

Just grasping at a straw here.



Jay
 
Status
Not open for further replies.
Back
Top