Here I am

Engine/Transmission (1994 - 1998) timing vs. power

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff
Status
Not open for further replies.
whats a good timing for say 3-400 hp, after i get my leaks fixed i want to start getting everything ready for bombing.



also whats ya'lls suggestion for rebuilt injectors?



sorry for always asking so many questions. :)



thanx



dt :cool:
 
Most guys run about 16 degrees timing. Rumor has it that more will blow your head gasket without o-rings, but there are those who run more successfully.



For injectors - just get 370s/Marines. Best bang for the buck by a long shot! If smoke is a big deal, run 300s instead.



Hope this helps
 
I agree with the 16 degrees thing. 16 was recommended to me buy Harry at Piers when I went to my PDR 370s. With a 10 plate, 370s, 3k GSK, 16 housing on my stock HX-35, 4" exhaust, BHAF and 16 degrees timing, I made 416hp 945tq.
 
What is standard timing?

What is the standard timing? My mechanic (Garmons in atlanta) advanced mine 5 degrees from that.
 
Status
Not open for further replies.
Back
Top