Engine/Transmission (1998.5 - 2002) Torquing Inj. Pump Timing Gear

[garylmoore]

What is the proper way of locking the engine to torque the injection pump timing gear nut? The recommendation I read was 165 ft lbs.
I've done this a number of times before and I believe I stuck a rag under the alternator pulley, but it seems there has to be a better way.
The injection pump is installed and the keyway is lined up with the mark on the timing cover.
Thanks

 

[GAmes]

I use a barring tool. '89-'24 Dodge Cummins Diesel Engine Barring Tool (genosgarage.com)

 

[Joseph Donnelly]

I also use a barring tool. That is way too much torque; I don't recall the correct value but it is somewhere around 100-120 ft b.

 

[BigPapa]

AllData says 125 ft/lbs.

 

[garylmoore]

I have never used a barring tool. I was under the impression it did not lock the flywheel in place, that it only allowed you to turn it.
Do I need a helper to prevent the barring tool from moving while I torque the nut? Thanks.

 

[GAmes]

No. Just slide it in the hole. It pretty much jams the flywheel/flex plate teeth. At least on mine it does.

 

[BigPapa]

With the barring tool in place, you have a gear with @ 200 teeth trying to turn a gear with 8 teeth. It will hold the flywheel.

 

[garylmoore]

With the barring tool in place, you have a gear with @ 200 teeth trying to turn a gear with 8 teeth. It will hold the flywheel.

Thanks to all that replied.. that is what I was looking for.. Gary