Here I am

Archived Turbocharger boost sensor low (0237)

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Archived dana 60 wheel bearing help!!!!!!!

Archived Installed bullydog pmt wont START!!!!!

Status
Not open for further replies.
Where do I start. I think this problem may be related to washing the engine. Everything was ok until then. I washed cold - usually I wash with the engine hot. Engine misses especially under load, full power on throttle is intermittant. Chuggs along but without any zip. Code 237
 
Last edited:
That is a MAP sensor code. You could try dielectric grease on the connector first but you probably need a new one.
 
I agree. The MAP sensor is a likely suspect. Several years ago a good mechanic pulled the starter on my '01 to install the contact upgrade kit. The next day when I hooked up my trailer and hit the highway I had low boost, low power, and couldn't make smoke with 275hp injectors. It was the MAP sensor. I think the mechanic accidentally damaged the MAP sensor.
 
Status
Not open for further replies.
Back
Top