Update on Pulse Manifold

[DHayden]

Any more people running the pulse manifold and have comments comparing them to the ATS manifold? Is your's coated and is it worth it?



http://www.htturbo.com/

 

[bmoeller]

Haven't seen one in person, but it looks like a nice piece. Been happy with my ATS unit. No coating. Either is one heck of an improvement over stock.

 

[joaker]

Did you have a chance to dyno before and after your ATS? I put one on but the difference was minimal, maybe a bit in the SOP department.

 

[Kernel]

Happy with mine, went together easy just some light tapping with a hammer. Had to use the studs out of an old stock manifold to mount the turbo correctly (ones sent with it were too long).



Scott

 

[swankmetal]

i was recently at htt and got to see one in real life. needed some napkins after that.



it WILL be my next major purchase. Oo.

 

[bmoeller]

Did you have a chance to dyno before and after your ATS? I put one on but the difference was minimal, maybe a bit in the SOP department.

No dyno. This wasn't a purchase specifically for better performance. It was needed part. Wasn't gonna buy another stocker to replace it. Plan to keep this truck for a lot more miles.



The idle EGTs are a little lower. Turbo spools a tad quicker. The drive pressure must be a little lower, because the max boost is down a couple, with no increase in max EGTs. Seems to breather better than a stocker. Can't really comment on any max EGT change, other than it didn't go up with the plate being slid. The plate was slid a few days after.