Attention: TDR Forum Junkies Has anyone tapped into the "Wait to Start" circuit for installing a remote starter for example?
I think the dash board light is just a signal from the PCM to the dash so the only real way to tell if the grid heaters are on would be to tap into one of the two relay circuits that go from the PCM to the two relays. Anyone done this and know where the best place to tap into is?
At least that's all I can see looking at the wiring diagrams in the tech. manual.
I think the dash board light is just a signal from the PCM to the dash so the only real way to tell if the grid heaters are on would be to tap into one of the two relay circuits that go from the PCM to the two relays. Anyone done this and know where the best place to tap into is?
At least that's all I can see looking at the wiring diagrams in the tech. manual.
