Who makes the axles for the 1T 05 Dodge 4x4?

[BGlidewell]

Did a search. Thanks.

 

[GWBourne]

American Axle Manufacture

AAM

http://www.aam.com/

 

[BGlidewell]

Thanks, I dont see a 4:10 listed there though...

 

[HOBrian]

4:10 ratio only for the 48RE auto.

 

[BGlidewell]

yes, so does the 4:10 auto truck not use a AAM?

 

[dan shss]

All the 03 and newer trucks us AAM axles

 

[GWBourne]

yes, so does the 4:10 auto truck not use a AAM?

alright, AAM is a bunch of cheesediks... a while back they had a listing for a 3. 54... lots of people with the 6 speed were looking to go lower on a ratio. i sent them an e-mail and the reply i got was we dont offer that ratio. i asked why it was listed and got no response.



i have not been back to the site since then. i have an AAM 11. 5 inch rear end, and i have 4. 10



the site is not acurate, you would have to call them or e-mail them for anything that could be accurate.

Grant

 

[CJPerry]

The AAM site is not geared toward consumers since they do not sell anything to the public. It is meant for anto manufacturers and shows products that are available to them. If Dodge decided it wanted to install 3. 55s, AAM would produce them. Same goes for all of the locker and limited slip options on the site. It looks like we should have five or six options but most of them are not available since the auto manufacturers have not purchased them.