Here I am

Anyone making 4000rpm's with a programmer?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

ANyone tried the ROI WORKHORSE module on a 3rd gen

Fuels lines - 3/8" or 1/2" ???

Status
Not open for further replies.
i know how to hit 4000 rpms haha i was messing with an edge ez one time and never to try it again, i modified something i wasnt supposed to and put it on the super j. t. special program, i started the truck and it idled fine but when i hit the throttle, the biggest cloud of smoke came out of the stacks and it ran away for about 5 seconds and then shut down and wouldnt start, removed the ez, restarted truck and it had very low power, blew the rail relief the tach was at 4000 and jumping around, it scared the crap out of me and i never tried it again, oh yah it killed the ez too !!!:eek:
 
i know how to hit 4000 rpms haha i was messing with an edge ez one time and never to try it again, i modified something i wasnt supposed to and put it on the super j. t. special program, i started the truck and it idled fine but when i hit the throttle, the biggest cloud of smoke came out of the stacks and it ran away for about 5 seconds and then shut down and wouldnt start, removed the ez, restarted truck and it had very low power, blew the rail relief the tach was at 4000 and jumping around, it scared the crap out of me and i never tried it again, oh yah it killed the ez too !!!:eek:



OPPS!:-laf
 
Status
Not open for further replies.
Back
Top