Here I am

Engine/Transmission (1998.5 - 2002) How to Smoke?

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

Engine/Transmission (1994 - 1998) Motor mounts for 1996

Engine/Transmission (1998.5 - 2002) No fuel

Status
Not open for further replies.
How do you blow the smoke? I know you have performance add ons. What rpms are you turning when blowing smoke? Just curious?
 
File off your injector tips or drill a 1/8 hole in the end... ... .....

You smoke when your air/fuel mix is too rich or low boost meaning no air to burn the fuel off.
 
not looking for more smoke just asking. you see the videos and these guys have the engine reving high. thanks
 
At what cost though?

a whole lot of fuel!!!!



Just wondering. For long term towing use not tractor pulls or 1/4 mile blowing smoke throughout most of your rpm's can't be good. This must leave (pardon the technical term:confused:) soot in the cylinder lining and valves causing premature wear?
 
Just wondering. For long term towing use not tractor pulls or 1/4 mile blowing smoke throughout most of your rpm's can't be good. This must leave (pardon the technical term:confused:) soot in the cylinder lining and valves causing premature wear?



YUP!:-laf

sure looks cool though!:-laf
 
eh, like I'm NOT going to get MORE miles out of this than I would get in a gas engine. I'll take SMOKE, more power, more torque, TONS more miles out of this engine than a gas engine anyday. When it pukes, I'll change it out and do it again! :D
 
I like CHornsby theory ... . oh ya after you file your injectors should you have them professionally drill at a machine shop... hum. . wondering. l might try that. . LOL.



Smarty 4+Drag Comp 5x5+BD90's+converter locked in OD @ 50mph+foot to floor= 50 PEOPLE BEHIND YOU STOPPING.
 
Status
Not open for further replies.
Back
Top