Engine/Transmission (1994 - 1998) stop-kill cable kit

[NScott]

Has any aftermarket vendor or other supplier packaged a stop cable kit to replace the stop solenoid. I see from some of the posts here that some of you have put some together from various pieces, but I was hoping to buy a kit that had all of the right pieces in it to start with. Help please!

 

[JHenry]

Roda Deaco

Is this what you had in mind?

 

[BSMcCauley]

I think he is looking for a fuel shut-off kit to replace the solenoid with a push-pull cable. The Roda Deaco unit looks like an air shut-off device.

 

[EKlem]

Yes, it isn't really a kit but you can get all of the parts from international. The P7100 was used on a lot of DT466's and you can get all of the parts for one of those. Hopefully someone can actually post up the part numbers.

 

[MMcCallie]

If you remove the solenoid setup, the arm will swing on its own. It is not difficult. You can then choose the pull cable of your choice. Hardest part would be welding the wire stop to the arm.

 

[vaicase]

i did it witrh a 10. 00stop cable from a farm store,and took off the shut off arm and cut it and twisted and welded it back together is it goes toward the rear not fontwards. and took a hose clamp and attached to the dipstick tube. works great for 4months no problems. the only thing is remembering to push it back in to start. and leave it out as i have a 5-speed it will start very easy on a hill. learned that in the army. 30years ago. thanks

 

[bighammer]

Check out this thread and see the pictures I posted near the end. It's a pretty simple task and very low cost.

 

[ata]

International cable shut-down parts list.

299399C1 Clamp

109420R2 Swivel

324877C91 Cable

371146C1 Knob

370782C1 Screw

436747 Screw

363423C1 Nut

These numbers are 3-4 years old. Was about $30 for everything.

 

[WPeschel]

International cable shut-down parts list.

299399C1 Clamp

109420R2 Swivel

324877C91 Cable

371146C1 Knob

370782C1 Screw

436747 Screw

363423C1 Nut

These numbers are 3-4 years old. Was about $30 for everything.

Do you have pics of this install??? Does this include everything or will I need to fab anything??

 

[ata]

Do you have pics of this install??? Does this include everything or will I need to fab anything??

No I don't have any pics. The only thing to fab is a bracket for the dash or drill a hole in the dash to mount the knob end and drill a hole in the firewall for the cable.

 

[WPeschel]

No I don't have any pics. The only thing to fab is a bracket for the dash or drill a hole in the dash to mount the knob end and drill a hole in the firewall for the cable.

Thanks I think I will go on a order these parts... Is there a place online to order from?? Where did you get yours?? Thanks

 

[ata]

Thanks I think I will go on a order these parts... Is there a place online to order from?? Where did you get yours?? Thanks

Sorry if I mislead you, I don't have the cable shut down on my truck. All the info. I have posted is from a thread from three four years ago that I saved. All the parts came from an International parts dealer. You might be able to get them online from International.