Here I am

Rear Wheel well Fender Liners

Attention: TDR Forum Junkies
To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.

Thanks, TDR Staff

DTC P0542; Intake air heater "A" circuit high.

Low Heat Output from vents.

Status
Not open for further replies.
I just noticed that my truck doesn’t have fender liners like my 03. Anyone add them to their truck? Part Numbers or aftermarket options for these? Would 2013-2018 liners fit? Thanks
3A4E32F8-3C6F-4106-A3FF-F083077F336F.jpeg
5A68DA8F-D367-4A60-9B76-530A1FAB58B9.jpeg
 
Bed didn't change so the liners should fit, but they can cause dirt and crud to sit in between them and the bed side causing rust issues along the wheel well lip. Mine is rusting there.
 
I've noticed them as factory options and beleive you can get them through the dealer or a favorite aftermarket vendor. I'm not up North where there is salt etc, but always installed them on our P/Us. If you decide to get them, you may look to see if there is a way to treat the metal to prevent rust like LD mentions.

Cheers, Ron
 
My 14 has them. It is odd this is even an option. Personally, I feel they are a necessity. Otherwise everything steel is constantly getting sand blasted from debris the tires kick up. I remove all 4 every fall to wash and spray wool wax. They dont collect as much as one would think but I suppose over the years it could add up. I would definitely look into them.
 
You'd think they'd just be standard equipment.. They make the rear wheel arch look finished and clean. I had to buy them for my 06'. I steam cleaned them and sprayed a can of 3M 08883 rubberized undercoating on the painted metal surfaces before installing them.
 
You'd think they'd just be standard equipment.. They make the rear wheel arch look finished and clean. I had to buy them for my 06'. I steam cleaned them and sprayed a can of 3M 08883 rubberized undercoating on the painted metal surfaces before installing them.
I think they are standard on some trim levels, or part of some other option package.
Mine came on my truck, but I didn't order them specifically.
 
Had to order them on my 2015 when I bought it. If they came with a package or trim level, you'd think a Laramie would have them. $100+ to the dealer!
 
OP's truck looks fairly clean. Could you take RTaylor's idea one step further and just LineX or whatever them...might even be quieter than plastic liners?
 
They came on my wife's 2019 Ram 1500... not listed separately, and doesn't have any snow packages, but although not mentioned, would have thought it would have been included in the off road package. At any rate a good option to have.

Cheers, Ron
 
My 18 came with them, but I don't see anything on the window sticker that would include them.

Then again I bought it used and maybe the PO added them in the 3K miles and 2.5 months he owned it.. but he didn't add anything else aftermarket like mud flaps, etc.
 
I ordered Rough Country liners 4609 for my truck. They are supposed to fit my 2017 1500 as well. The liners in my 1500 are beginning to fall apart, 142,000 kms. If they don’t fit I’ll put them in 1500. I’ll undercoat fender before I install them. I’ll post pictures of install if I remember. Getting a new truck isn’t cheap to get it set up properly.
 
My 18 came with them, but I don't see anything on the window sticker that would include them.

Then again I bought it used and maybe the PO added them in the 3K miles and 2.5 months he owned it.. but he didn't add anything else aftermarket like mud flaps, etc.

Is it part of having Fender Flares??

I could get off my butt and look at my window sticker but...... I don't care enough :)
 
If it was fender flares wouldn't that be all Laramie trucks?

I do know that they don't cover nearly as much as the ones on my 05 did.
 
Status
Not open for further replies.
Back
Top