Recent Content by AGSmith

Any ideas on which gear oil to put in i have a 10 bolt Dana 70 should i use 75-140 SYN or reg #90 any help would be great.

I've have some noise coming from underneath my truck seems like. Any ideas of when to change my center support on the drive shaft and also U joints?. Should the drive shaft move up and down a little bit from the floor when pushing on it. Any help would be great.

So i eventually got it off,I took it apart i had already brought a LarryB's #R 90 SS from Geno's for about $24. 00 I took out the plunger and removed the contacts I used a 17mm open wrench on the outside nuts and a 14mm to hold the one contact when i was tightening back up. Cleaned all the...

A good friend came over with the right 12 point 10mm 1/2" racket qrack it was loose thank's every one now i just have to fix it or change it.

If only i could be that lucky,Lucky dog.

I will go and get a heat treated 10mm if that's possible so it won't break. thanks for the reply.

Hi everyone, Broke everything else loose, can't turn that top 10 mm bolt. Wow it's tight,should i put some heat on it like map gas or something already broke a 10mm socket the others i tapped loose with a small brass mallet and a wrench. That one is to tight to swing a hammer,any ideas would...

Good to know,maybe i'll like it louder.

Thinking and wondering if it would make any difference in performance to change out my waste gate for a Bank's Big Head. Has any body done this and notice an improvement. I'm going to put a #5 throttle plate in it soon,any sugestions. Is the hissing sound i hear sometimes when i'm driving...

Thank's Bob, I will look into them. My solenoid was in really bad condition i think it was the original since '97 so i did change it out. I am going to do my starter very soon, as it's starting to play up. Thank's again for your reply.

I think my solenoid is out because everything it hooked up but it dosn't come on when i flick the switch,and the switch has power. I havn't had the chance to have another look at it. I'll let you know what i find. i still have good power when switch is on.

Yeah, that's why i don't smoke ciggy's. I do safety hazard material training for my job. I'm bombarded with this stuff all the time it becomes quite brain numbing. But it's good to be aware.

Thank's, I think i'll leave mine alone, i just wasn't sure if it would change anything with a straight through pipe ,makes sense though.

The little red wire was on ther illumination fuse. I switched it to the N/A fuse next to it, i used a 20amp and it's all good egt's are sitting around 240- 280 at idle.

Hi everyone, Has any body out there swapped the muffler under their truck for a straight through pipe. Does it make it alot louder and does it give any extra power or does the engine need some back pressure to run good. ? I can't remember if somebody told me this, or if i had a dream...