Recent Content by alexanderJ

. I am concerned, and considering the fact that the truck is 20 years old it is is extremely good condition inside and out. I'd just like to make sure it continues to be reliable for a few more years. @steve69 Engine temp runs 190 to 200 degrees when towing, and doesn't seem to increase in...

Thank you. There appears to be lots of data on the web that supports that.

Yes using tow haul, but on the '05 tow haul only changes the shift points. It cannot be used to lock out OD. And yes, only seeing those temps when TC unlocked. At highway speeds in 4th gear TC locked all is fine.

I've found very few threads on this issue. If you could link me to some of these discussions you mention I'd really appreciate it. After the mention above of the temp range of newer synthetic transmission fluids I did a little research and it appears that 220 - 230 is not that big of an issue...

I'm probably around 9K loaded. I wouldn't have been concerned at 200 like you but when I hit 220-230 every now and then I get uneasy. Especially since the truck is 20 years old. I would just hate to be in the middle of nowhere and have the transmission or TQ crash. However, based on Ozy's...

Yes Sir. Transmission cooling system is factory stock. I routinely inspect and clean radiator. I completely flush/change the oil (18 qts) every 25K miles. I've though about adding a deep pan, aluminum with fins, but from everything I've read this won't help much. I'm just trying to convince...

2005 2wd 2500 CTD 125K miles. Excellent condition. I need advice. My transmission is shifting fine and I'm having no issues except for noticing higher transmission oil temps when pulling my 5th wheel trailer. For many years I've noticed the temp as measured in the pan to reach 220-230...

Not to beat this dead horse, but I pulled the side plug and got no overflow, and the level was still perfect at the hole. The only explanation I've come up with is the fact that when I drained the fluid it was still warm from a 30 minute drive. Normally I drain it cold, but completely. Maybe...

Copy that.

No, cover stayed on as usual. My garage floor is level and this is exactly the same location as previous changes. Thanks for input. I'm going to drive the truck today, and then remove the side level hole plug and see if it pushes any fluid out.

Yes, that's what I'm thinking. It's been so long since I installed the cover I'm not sure if the manufacturer stated a capacity or not. The issue is why the additional .5 qt this time? The PML cover has been on the truck for over 3 fluid changes now. The first two required 4.5 quarts. The...

Can't use mfg. spec as the after market PML cover adds additional fluid to diff. I don't know the exact amount. No dipstick to check. Yes, front pinion seal.

I have a 2005 2WD CTD 2500. Years ago I put a PML cover on the rear differential and when replacing the fluid filling it until the fluid would start to run out the side fill hole. This usually ended up being 4.5 quarts. Last week I had the front seal of the rear end replaced. On changing the...

If someone just has to have the switch active in the console, I think this would be the answer: https://www.digikey.com/en/products/detail/judco-manufacturing-inc/40-4169-00/611176 I'm not certain this would be a drop in replacement and that you could still push on the lens and activate the...

Not sure what you mean by the dime, but if they are used that means they are old and the plastic switches have deteriorated. Unfortunate they don't break, the upper and lower part of the switch body separate, probably due to heat.