Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
TDR Magazine subscribers receive more than the magazine! You also gain additional forum privileges!
Details here: TDR Privileges
Subscribe to TDR Magazine here: https://www.tdr-online.com/
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Recent Content by APacitti
Attention: TDR Forum Junkies To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.
I just ordered a set of nitto terra grapplers in a 305/70/17 E load range, i wont have them for a week or so but I've had good luck with a previous set on another truck. They are a little bit smaller than the procomps i'm replacing but they are rated for 600lbs more per tire so i feel the trade...
I've been running the two together now for about 6 months, if you leave the edge on 0/stock everything works just fine. The juice will add some boost fooling which will allow the Smarty to build a little more boost than it normally would. Unfortunately i have had very little luck running the...
I believe people were actually referring to South Bends dual disk clutch. I too could be interested in a DD, depending on price. I was going to wait awhile but if the price is right i may as well do it now.
Let us know
Thanks
Where you guys really running the edge on 5 and smarty 9?, didn't it have horrific timing rattle? The edge and smarty really don't mix well at all even on mild settings.
I've recently switched to a smarty and have been towing with the most recent beta software. I've found it has as much if not more power than the juice had. The best part is when towing my temps are down a lot compared to the juice, with the revised boost tables you get a lot more boost with a...
The previous version (stock) of the smarty helped with my boost problem but it was still an issue. However i have recently downloaded the new beta (Thanks Bob) software and set on level #3 it has pretty much eliminated my boost issues. This is with my juice still installed as i can't remove it...
I have the same problem expect mine seems to be okay with my edge removed and my smarty seems to help but not cure it. Last winter/early spring i did discover some interesting stuff on the way to AZ from MN. I discovered that in my case at least its not the temperature but more so the air...
I also have both units, i would like to add that on a mildly modded truck the hot juice seems to be a little quicker and the truck seems much happier than with the smarty. The smarty does have much better low end response and seems to be the more powerful program, especially with the increase...
I too have been playing with the smarty and Hot Juice and this point i have to say i'm a little disappointed with the smarty. I would say that the lower power smarty settings are just awesome and the throttle response on any of the tq mangement settings is great. But the 100-170hp settings don't...
Please give us some feed back on your new turbo, i've been looking at the same thing and i'm curious how you like it. How does it spool?, any surging? and what kind of temp reductions are you seeing?
I've tried to search for answers to these question but I've come up short so here i am. My truck has all the mods that are in my sig, however very soon it should have a fuel system and a smarty in the place of the hot juice. I'm looking to purchase a single turbo, i tow single vehicles/boats...
I also have the pro comps and so far they seem pretty good. I like them alot more than the bfg all terrains they replaced. They seem really strong in deep snow and are holding up okay. Hope this helps
Alex
My car trailer did this when i first got it. I assume you have a seven way plug? In my case the pins inside the trailer plug were contacting and the power feed for your trailer battery was contacting the back up light terminal. To fix it i pulled the plug apart and made sure the terminals were...