Recent Content by BEnglish

I got one from auto computer exchange. They were the cheapest (look for them on flea-bay) and came with a warranty.

I had a similar problem, the truck would just turn over and not start till the WTS light came on and I heard the LP bump. On mine it took around 15 seconds till they did come on. It turned out my ECM was bad and a replacement fixed the problem. I did however have other issues that also...

dirty air filter?

I do have a turbo timer built into my alarm, but when it’s close I just sit and wait because I hate leaving my truck running while unattended. Also, I come home from work late because I work late and I live in the suburbs and I have a big exhaust, so the quicker I can shut it down the better...

Shut down at 300 or 350 deg? A search didn’t make me satisfied on an answer so I will ask. What temperature do you guys shut the engine down at? I used to wait till 300 but read 350 was OK so I started doing that. But now I am a little worried about it and was wondering what ya’ll do?

14,000 miles ago I put on new Napa premium rotors and ceramic pads. Two days ago I heard a grinding and so I pulled the tires and checked and sure enough, all the pads are almost gone and one is into the new rotor. I put new pads on but can't figure out why they would only last 14K miles...

I was replacing the ECM for another reason, so the original one I had made my truck run fine. The one they sent me (same one three times) didn't even start my truck so I was forced to put the old one back in, which like I said, made the truck run fine (had another problem). They did listen...

bezel cover from Geno's full replacement dash from Geno's Chrysler paint from Geno's

I want to update with my progress. Well after ACE sending me the same ECM 3 times and it not communicating with my injection pump control module all three times, I asked them not to send it back and to send me a different one. They did and I put it in and the engine fires right up. I am now...

If I remember reading my FSM correctly, the OEM alarm uses the CTM, and if you have an aftermarket alarm, the installer may have connected to it or its wires in some way.

i will chime in here, I did the full replacement dash from genos and did the bezel cover at the same time. Very happy with the fit and finish. I painted it myself with the Chrysler paint.

I had a clunk and it was the receiver hitch. :rolleyes:

I did that to a new pump and big difference, I can push off a curb with the front end (but of course I only found that out on accident LOL) but the brakes and steering work well at the same time now even standing still if I have to. I have a PSC box and called to ask if it was dangerous to amp...

Dodge can reflash the ECM in the truck, Cummins can reflash it in or out of the truck (at least the one by me can).

TREs - and the attached links I got from Napa pitman arm- (There is only one) and I'm not sure where you would get a replacement but others around here may. TB - I replaced mine (I have a 98 4x4) first with an aftermarket adjustable one but the alignment shop wouldn't align it because they...