Recent Content by BLoging

ok I am try to find a old thread on here that showed step by step of a install of a derale 15950 transmission oil cooler if any one can find it for me it would be greatly helpful as I going to be getting it installed on Monday at a shop near me, and he wanted to see how someone on here had...

check the hose too as they can swell shut and not let the brake fluid return for the caliper.

how about west central Wisconsin around Lacrosse area!

is it possible ice build up?

I have had this done the rubber hose swell on a dodge Dakota and roosted a set of rotors and calipers twice all because of hose, the first time just replaced the rotors and calipers and pads and less than 2,000 miles the same thing again so I just pull one caliper off and tried to push the...

my 2004 has the catalytic converter but it had the sticker saying 305 then after a program up date now the sticker is gone and was told after the update was done now is 325. as my build date was the last week of the 305 and my truck was on the last day before they switched over to the 325

stop to a local install area the put's in radio's and ask how it comes apart. that how I did mine. there may be two to three screws and the rest may be spring pins/clip's

from what I remember in tow/haul mode pushed on, the torque converter does not lock and it locks out the over drive (4 gear), if I remember right when reading the owner's manual!

just got back from the dealership(stealership) to get the recall done and to get the tie rod end that is up by the pitman are and after the got done they came back with a quote of 2800 bucks :eek: to have new upper and lower ball joints and sway bar end links and u-joints and to have the 08 up...

that is ok I was just going to reply back to your text and say that I do not have that much money to buy it from you and if you had any other persons asking for it you can let the next one in line have a shot at it.

what are you asking for the Gear Vendors overdrive w/NV271/273 adapter? you can text me the price at 608-484-0203

about the same here 15 to 20K or until the low pressure lite start's to flicker a bit under a full power take off.

I have the fass platinum and it use one spin on and it is a Donaldson and I change it about every 15,000 to 20,000 mile depending on if I get the low fuel pressure light that I have (that is made by BD diesel) as it comes on at 5 psi or less. but I will change the factory motor mounted filter...

is it still available?

if you can please do, it would be very nice to see some of the thing's that the other tour's may have missed