Recent Content by CChaney

what were you doing on rd 29?I live in that area there are a lot of losers that speed down the road drunk afew of my freinds have been hit in the same area. Did the guy stop. I hope you got a peice of his ass.

I have that programmer it is fine on the lower settings but I do not feel any difference from the 50 hp to 70hp change also you don't get a boost elbow or a fooler so you truck will throw the check engine light on . By the time you buy the elbow and fooler you could have bought an edge ez. There...

thanks Vic I was hoping my gauge was not bad. but I have pulled my stick out of the transmission and touched the fluid and it felt about 120 when the gauge read about that

I have been reading that you guys with autos see about 140-200 degrees on you trans temp gauge . I have my probe in the pan when traveling it reads about 100 degrees and one time in traffic it went up to 150 but that is it normally its about 120. seems to low also my transmission slips into overdrive...

tires can and due cause a pull sometimes. We call it RTP radial tire pull. the shop or you should cross the tires left to right and it will due one of two thing most of the time 1 it will stop pulling then you are done 2 it will pull the other direction and then the tire should get replaced ...

hey guys I own an alignment shop get the new tires first it does not make that big a deal but its the best way also make sure you have your truck loaded about the normal wieght that you carry. and make sure your tire pressure is set where you will be keeping it . The pressure makes a...

I have the superchips micro tuner and it came with a cable that looks like the plug on the back of my laptop. I also downloaded the obd2 software does any one know if I can use this combo to look around my trucks sensors? the truck is an 98. 5 24 valve 4x4

chip the mudkings are crap I am a dealer and you will not get your moneys worth. there were a few tires brought up that are also crap the superswamper will wear out in 25000 at best. the mud rover is ok at best for wear but traction is great. I am not a big fan of bfg because we make swat on...

Pack the bearings with grease it takes a little while to get the gear oil out to the bearings and you will beglad you packed them. It cant hurt and the spindle is part of your housing so if you fry a bearing you also bought a new rear end.