Recent Content by DScoville

I'm mobile again, thanks guys. Don

Thanks Francis, I used that site and have a driveshaft on the way. Don

Thanks bg. I'll be making some calls in the am.

I am in Elkhart Indiana area and lost the rear half of my 2 piece driveshaft. Anyone know where I might find one? I also may need a pinion flange. Fits 03 2wd quad cab 6spd standard.

Temp around the same and just quit snowing.

I disconnected the quadzilla when I first pulled over to change the fuel filter. The Edge is just a monitor that plugs in the interior port under the dash.

The rail pressure showing on my edge CTS was fluctuating from 1800 to 2800 psi

Fixed. . Thanks to Todd at T&C diesel. There was water in the connector for the rail pressure sensor. Thanks for the reply Mike. Once again Thanks Todd.

My 03 started acting up about 20 miles ago. It was making a lot of ignition rattle and surging. If I applied any throttle it would immediately rev up to about 3000 rpm with a lot of black smoke and bucking. Not long after it quit. I pulled over and changed the fuel filter and it started again...

Thanks for the info guys, as soon as I get out of snow country I'll switch to my spare pump.

Also, the pump is a year old with about 180,000 miles on it.

The FASS pump I am using is the direct replacement kit and didn't come with a relay. It just plugged in to the stock plug. Since I originally posted this morning I have been driving the truck and this problem has happened twice. Both times I just turned the key off momentarily and then restarted...

I am having an intermittent fuel delivery problem. It started yesterday morning as I was driving on the highway pulling a 34' fifth wheel. The truck works fine at around 10% throttle or less. As soon as you give it any more throttle it stumbles and almost dies. The rail pressure drops...