Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
TDR Magazine subscribers receive more than the magazine! You also gain additional forum privileges!
Details here: TDR Privileges
Subscribe to TDR Magazine here: https://www.tdr-online.com/
You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Recent Content by DStauffer
Attention: TDR Forum Junkies To the point: Click this link and check out the Front Page News story(ies) where we are tracking the introduction of the 2025 Ram HD trucks.
We are driving the truck from Minnesota to Montana for skiing again this year and I couldn't put up with the loose steering any longer.
After reading this thread and others I installed a Borgeson steering box and steering shaft in the truck last night. It wasn't too bad an install and took...
Nope, they didn't replace the tone ring. Here is the invoice...
Cause
Engine speed sensor failed
Correction
(shortened up... shop stuff)
Troubleshoot - ISB, Active fault code No. 115
Engine speed sensor - Remove and install
Remove and reinstall starter
Drill out broken engine speed...
Here is an update...
I couldn't get the code reader to connect, I needed to get the truck running, so I took it to the Cummins dealer (33 miles away).
They found the "speed sensor" broken in half. They said they had to pull the starter to get to it. Charged me $600 for everything.
I...
Insert red face here... I have AutoTap ODBII code reading software and interface cable installed on an old notebook. I bought it for my Jeep several years ago and haven't thought of it since. I will drag it out tonight and see what I get. Will probably have to update the software. At least it...
Thanks for the suggestions. I think wiring past the ECM and directly to the pump is the best and cheapest fix.
I was looking at the service manual and it says that the Fuel Relay in the PDM is only for gas engines. I had it pulled, turned the key and the pump ran for a while. The diagram...
Hi All,
I've been lurking here for a couple days trying to solve the non-starting truck (1999) issue. After reading all I could find, here's what I've got...
The lift pump is only getting voltage about 1 in 15 key turns. When it gets voltage, it pumps about 45 oz or so of fuel. As one...
Hi all,
I've been lurking for a couple days trying to troubleshoot an issue. Truck (1999) was running fine one day, next day won't fire.
I noticed (not at first) that I couldn't hear the lift pump running when I turned the key. I did the volume test found in one thread and got the 45ish...