Recent Content by ed9824v

I will load test the terminals on the battery because this started after changing the batteries

The battery lugs I have allowed me to remove from battery without removing any cables, than a for the question

Thanks for your reply? Well above 54 degrees. The reason I asked is that it has always in the past came on at any temperature outside. Maybe for some reason it now working properly.

I do not get the wait to start on the dash, I do not hear the buss associated with it. Starts and runs fine. I did just remove and replace both batteries, this seemed to occur after that. Any thoughts?

do a google search for Timbo's TPS it is a bullet proof replacement for the stock one and a lot cheaper.

no problem

I have an entire dash from a 1999 Ram 2500 in So. Calif. not sure that is of any value I can send pictures.

My abs sensor in the rear went out and did that

I have told the ecm serves another purpose, and that is to pulse modulate the 12 volts to prevent too high of a pressure at start.

that is one of the steepest road in the US. Sound like you are doing great, that road is a challenge without a load.

nice job good to know

May need to remove and test on a regulated air supply

I have removed them from the emergency brake cable mount. The last one I did recently on my hhr came with the emergency brake cable bracket and no horseshoe clamp. They clamp around a pin like a circlip does

I can recommend Betty Sutherland Sutherland Diesel 6612668866 Lancaster CA. Give her a call she will talk your ears off on your 24 valve. This is her passion. Tell her Ed Ginsberg sent you.

not to get a bunch of bad write ups, that is what I have on my offroad buggy for checking the amount of fuel in my buggy mine uses some 1/8 clear fuel line with quick disconnects.