Recent Content by ESchmidt

does any body know what other dodge models share the same a/c compressor clutches that 12v trucks use. thanks

I switched out everything that was different on the v10 from diesel. i checked the pcm at the pins going out and its shot. new ones on its way. i think i have a asd relay problem too. its getting no power but if i read right it gets a voltage from the pcm so that would explain that too.

i am getting no wait to start light, and i have no idea if there are any codes, no scan tool

So I have everything in and truck runs and drives great (thanks steve!). I have a 96 pcm and wire harness and a 97 truck. I have no guages except oil pressure. I started noticeing that the charging system was not charging then after reasearching i found out that it gets its trigger from the...

i feel kinda dumb, but its still confusing. i loosened the starter bolts about a turn, and it now works.

i have tried starters from both a manual and auto, the starter spins, and the bendix comes out but from the looks of it it is crashing into the flywheel (shiny spot on flywheel about . 40 to . 50 of an inch from the end of flywheel teeth). will try to get a pic up tomorrow. the truck does not...

i am pretty sure my clutch is a 12. 25 because it came from a 97 truck. it bolted to the flywheel just fine. what would my options be if the flwheel is indeed a 12. 25 and the starter is crashing into it? what else could the flywheel be from?

i was thinking about that but would a 12. 25 inch clutch and pressure plate bolt up to the 13inch flywheel?

I am using a flywheel from an 01 with a nv4500 trans in my 97 v10 auto to cummins 5spd swap. the starter is crashing into the flywheel teeth from the looks of it. i have tried the starter from an auto cummins i had, and one for a 5 spd. neither work. i am starting to get fustrated and need help...

I am doing a cummins transplant into my v10 the truck is a 97 and the donor is a 94, i am worried about the plugs going into the body harness, the 3 plugs if your looking at the front of the truck they are on the right side. they are different on both trucks. i am wanting this conversion to be...

i have 2 questions. i just picked up a nv 4500 for my swap and it has the old style top plate on it but it has no shifter in it. the hole is empty. where can i find one of these reasonably priced? my next ? is where to find a 29 spline input shaft for my t case, i have called bluementhal and...

i cracked a line, took the plunger out, i have fuel to the lift pump, to the filter, to the injector pump, comming out of the injector pump and comming out of a line going to the injector. it actually sounds like it wants to start, but it doesn't. how common is a stripped gear on the injector...

i dont think it has an air leak, it didnt act up, or sputter it just flat out died. it wouldnt even act like it wanted to start after.

well i went back today and fiddled with it some more. fuel solenoid is hooked up, and i can hear it click when i unhook it, and i also ran a jumper wire to make positive the wires were ok (test light showed current) i unhooked fuel supply line and cranked to make sure fuel was getting to the...

quarter tank. as far as i know the solenoid ishooked up, can it just come unhooked? i was so mad i walked home and didnt think to check that till i got home.