Recent Content by Himelwright

Sure hope some one out there can help some time ogo my alternator shorted out the PCM control circuit,new alter. and a extanl reg. and I go down the rood. COME CAL SMOG I have a CEL I fale. Order remananufactured PCM from auto computer exchange #1 no reading of oil presure #2 no...

Sure could use some advise my PCM is bad and my alternator is about there. I have no voltage out of the PCM to the alt. and when I took the alt. apart the slip rings were shot. Is the mean green the best alt. and what is the best PCM thanks in advance for the help.

My check engine light is coming on but my scan tool says there is no codes stored , I was getting radome codes stored 1492 ,1693, did battery maintains now no codes just the light . 98. 5 3500 4x4 stock

thank you will try that.

my frount brakes are draging very badely ?? what is best rebuld the calpers or replase them,Where is the best place to get the parts. thanks awhole lot in advance.

I am installing a gauges set FP EGT Boost . From reading in here is it best to install the EGT probe pre turbo? The instruction say post. Where is the best place to pickup the boost pressure? Thank you Chuck 98. 5 3500 4x4 stock except for gauges if I ever get there

I think I have a ECM. problem. The check eng. light is on and the Auto Zone scan tool will not reset it. The code it reads is 1693 (DTC in ECM & PCM). Several questions. ! What are the symptoms of a bad ECM? 2 Will the "smarty" act as a scan tool read coeds reset them? 3 What...

my vp 44 died got a replacement from industrial injection (good service),Did the lift pump reallocation,cleared all the codes now i get a 1693 code . I can clear it but it comes right back. Thanks 98. 5 3500 Just stock

Where can i buy a very dependable vp44 for the best price ? Thank you, C. Himelwright 1998. 5 3500 4X4

I am installing a gage set in my truck it would help if I could git a chemical bound as well as a thermal What type of plastics is my dash made of it is not PVC. or ABS Thaks for the help Chuck 1998. 5 3500 4X4 stock for now but with HOPE.

My Check eng. light is on. Took it to local dealer, said PCM had a short? and dodge no longer supports that part. My scan tool will not talk to it. The trick with key will not work. 1 what to check? 2 where is the best place to get a good unit. 3 is there some after market part to replace...