Recent Content by Iaff284

Hey Cerb, thanks for all your help with this. I have ordered a converter from DPC and a stage 2 rebuild kit from Dynamic Transmission. Jon was incredibly helpful and put together everything I needed. Thanks again for your help!

Will I need an endplay and OD shim kit? I have also seen where some people order a complete bushing kit and a thrust spacer kit? Sorry for all the questions, just trying to make sure I have everything when I tear it down.

Cerb, I think this is my plan a rebuild. Can you let me know your opinion and any recommendations. DPC Single Billet Conveter Cascade Super overhaul kit. http://www.cascadetransmissionparts.com/index.aspx/ImageGallery/Index?productId=1597 Raybestos GPZ clutch kit with OD Brake, RGPZ-016 Tcc/OD...

Well, went to take my daughter to school this morning and got halfway there and no forward or reverse. It was shifting very softly as we drove and then would not move at all. If you shut it off and let it sit it will drive for a very short time and then stop moving. The engine just revs and...

Sorry Cerberusiam, are you refering to the front clutch? I looked at the chart in the FSM and it shows the front clutch applying in 3rd, 4th, and reverse. The FSM is a little confusing in that it refers to it as the front clutch in the chart but then calls it the direct clutch later. I confused...

Can I just rebuild the OD unit? I really need this truck functional and I don't really want to pull and rebuild the entire trans.

Well, reset thebrear band to 3 turns, reverse is the same maybe a little worse. Now there is a 1-2 shuttle shift. I tried adjusting the cable to take out the shuttle without success. It is possible that 3rd and 4th are slipping under moderate throttle. It does engine brake if I go into M1. At...

Manual first feels fine. I will reset it to 3 turns. Can I air test the OD direct clutch to see is if it is shot?

Hey Cerb, I have not had a chance to check the pressures yet but I am having another issue that I am hoping you have some suggestions on. I put a shift kit in and some accompanying parts and adjusted the bands. The both bands were torqued to 72 inlb and the front was backed off 1.75 turns and...

Thanks cerberusiam! I was hoping you were going to comment. I will disconnect the TV cable and advance it fully by hand at idle and see where its at. I am also going to hook up the gauges and drive and see where everything else is at. It looks like besides idle just follow the test procedures...

Thanks cerberusiam! I was hoping you were going to comment. I will disconnect the TV cable and advance it fully by hand at idle and see where its at. I am also going to hook up the gauges and drive and see where everything else is at. It looks like besides idle just follow the test procedures...

Hey all, I have recently had some transmission issue and have gotten them resolved. This is on a 2003 2500QCLB 4x4 with the 5.9 HO and the 48re trans. My question now is what the appropriate pressures should be. I am currently at 88psi at the accumulator at idle. I am going to get a 300psi...